The Software Options section contains a list of all software options for the CMU. The check boxes behind each software option determine the system configuration:
Enable | Enable (box checked) or disable software option. Options purchased with a new unit are already enabled. Software options purchased later must be explicitly enabled with a key code to be functional; see below. |
Ch1 active Ch2 | Activate (box checked) or deactivate software option on the
next reboot. After deactivating an option by unchecking one of the boxes,
the CMU displays the following message:
Deactivating software options that are temporarily not needed improves the system performance, especially during the start-up process when all active firmware options must be loaded. An enabled but deactivated option can be re-activated any time without any key code or other additional input. |
Note:
Some options, e.g. CMU-K39 to CMU-K43 are supplementary options extending
the GSM-BTS and GSM-MS options. The supplementary options must be enabled
with a key code but can not be deactivated. No Ch1 active Ch2 boxes are
provided.
Enabled options are active by default. Disabled options are inactive and
can not be activated.
Remote control
SYSTem:OPTions?
*OPT?