Home Previous Next


Settings/ Scalar Measurement Results

Settings and scalar measurement results are indicated in the two parameter lines above the test diagram

1st Parameter Line

The first parameter line contains the following settings:

Ref. Level Reference level; upper edge of the diagram as set with the Analyzer Level - Ref. Level hotkey

.

   
Level and time of delta marker 1 (setting absolute) or difference from reference marker (setting relative)
   
RBW Resolution bandwidth (Auto or numeric value)
 

2nd Parameter Line

The second parameter line contains the following marker values:

Level and time of reference marker
   
Level and time of delta marker 2 (setting absolute) or difference from reference marker (setting relative)
 

Remote control
Settings are read out using the query corresponding to the setting command (setting command with appended question mark).
To obtain the measurement value at a single point on the trace the whole trace must be read, see below.


Home Previous Next