All function groups and test modes available on the instrument are arranged in a tree view showing the function groups and test modes to be saved to a configuration file. When the popup is opened, the configuration tree is expanded and the active function group and test mode is selected. The tree view is identical to the tree in the Reset menu.
The Base system is part of every software configuration and therefore selected by default irrespective of the current function group and mode. It is possible though to exclude the base system settings from the configuration file by deselecting the Base node.
Note:
If the base system is excluded from the configuration, the current function
group, test mode and measurement menu are not stored to the configuration
file. In this case it can be useful to write this information to the file
comment; see Change Dest. softkey below.