CONFigure:MULTitone:AF1Channel:LIMit:LINE:ASYMmetric:UPPer
CONFigure:MULTitone:AF2Channel:LIMit:LINE:ASYMmetric:UPPer
<Limit_1>, <Enable_1>, ... <Limit_20>, <Enable_20>
|
<Limit_nr> |
Description of parameters |
Def. value |
Def. unit |
|
-80 dB to +80 dB, |
Upper limit line at tone <nr> |
See below |
dB |
|
<Enable_nr> |
Description of parameters |
Def. value |
Def. unit |
|
ON | OFF |
Enable upper limit line at tone <nr> |
ON |
- |
|
Description of command |
FW vers. |
|
This command configures the upper limit lines and enables
the limit check at the 20 test tones that can be defined via |
V 3.0 |
| By default, the limit check is switched on at all tones and the following limit lines apply: | |||||
| Tone <nr> | Limit Line/[dB] | Enable | Tone <nr> | Limit Line/[dB] | Enable |
| 1 | -9.5 | ON | 11 | +5.6 | ON |
| 2 | -6.2 | ON | 12 | +6.3 | ON |
| 3 | -3.8 | ON | 13 | +6.9 | ON |
| 4 | -1.9 | ON | 14 | +7.5 | ON |
| 5 | -0.3 | ON | 15 | +8.0 | ON |
| 6 | +1.0 | ON | 16 | +8.6 | ON |
| 7 | +2.1 | ON | 17 | +9.1 | ON |
| 8 | +3.1 | ON | 18 | +9.6 | ON |
| 9 | +4.0 | ON | 19 | +10.0 | ON |
| 10 | +4.8 | ON | 20 | +10.5 | ON |