In the REMOTE state no menus but only the header Remote is indicated.
Remote screen
| Report Display | The Report Display hotkey can be activated (state ON, press the ON/OFF key) to display the input and output strings of the remote-control interface on the Remote screen. The remote display consists of three columns: |
| <Input/ouput> | Colored symbols for input (->) to the CMU, output (<-) or error messages (E). |
| Fct. Grp. | Name of the addressed function group; see description of
command SYSTem:REMote:ADDRess:SECondary in Chapter 6 of the
Operating Manual. |
| Command | Input command string, response/output string of the CMU or
error message
This parameter can also be set in the Setup – Remote menu or in the Remote Service Tool; see chapter 1. |
|
Remote control |
| Report File | The Report File hotkey can be activated (state ON,
press the ON/OFF key) to write the input and output strings of the
remote-control interface to a file named Remote.trc in the root directory
of the internal hard disk (INTERNAL directory in the Data
menu or directory C:\temp). The two softkeys Report Display and
Report File may be active (ON) at the same time.
This parameter can also be set in the Setup – Remote menu or in the Remote Service Tool; see chapter 1. |
|
Remote control |
| Local | The Local hotkey switches back to manual control. The current measurement and generator states and the current signalling state (if a Signalling test mode is active) are preserved. |
|
Remote control Equivalent CMU-specific command, also for operation via
serial interface: |