The event reporting system specifies in which way the CMU reports that a measurement or a measurement step has been correctly terminated, i.e., that the measurement status STEP or RDY has been reached. Event reporting is configured for each measurement group individually by means of the commands
CONFigure:<meas_obj>:EREPorting SRQ | SOPC | SRSQ | OFF
The parameters have the following meaning:
| SRQ | Service request. A service request is generated (i.e. bit no. 6 (RQS/MSS) of the status byte (STB) is set) whenever the measurement status STEP or RDY is reached (see section Service Request). |
| SOPC | Single operation complete. The operation complete bit (bit no. 0 in the event status register) is set whenever the measurement status STEP or RDY is reached (see section Overview - Status Reporting System). |
| SRSQ | A service request is generated and the operation complete bit is set. |
| OFF | No special action is taken when the measurement status STEP or RDY is reached. |
Note:
No action is taken if the STOP state is reached due to an explicit STOP
command.
Symbolic Measurement Ready Evaluation: