RF Tx Output

RF Tx Output

The RF TxOutput softkey defines which of the three connectors RF 1, RF 2 and RF 3 OUT is to be used as RF output connector for the Tx signal. The selected RF output is indicated by a symbol. If the additional RF signal Aux Tx is selected (see above), the softkey is labeled RF Aux Tx Output and selects the output connector for AuxTx. Aux Tx must be output at RF1 or RF2.

Note:
Input and output connectors can be combined at will. The bidirectional connectors RF 1 and RF 2 can be selected as RF inputs and outputs at the same time.
The LEDs on the front panel are only “on" (light) if the output level is switched on.

Remote control
OUTPut[:TX][:STATe] RF1 | RF2 | RF3
OUTPut:AUXTx[:STATe] RF1 | RF2