Home Previous Next


Device-specific error

The following errors cause bit 3 in the ESR register to be set.

Error code Explanation
-300 Device-specific error
-310 System error

An unspecified system error has occurred.

-311 Memory error

An error was detected in the device's memory.

-313 Calibration memory lost

Nonvolatile calibration data have been lost.

-314 Save/recall memory lost

Nonvolatile saved data have been lost.

-315 Configuration memory lost

Nonvolatile configuration data saved by the device have been lost.

-330 Self-test failed

An error occurred during the internal self test.

-350 Queue overflow

Error code entered in the queue in lieu of the code when the queue is full. It indicates that an error occurred but was not recorded in the queue. The original error message is lost.

-360 Communication error

An unspecified communication error was detected.

-361 Parity error in program message

Parity bit was not correct when data were received on a serial port.

-362 Framing error in program message

No stop bit was detected when data were received on a serial port.

-363 Input buffer overrun

Software or hardware input buffer on serial port overflows with data caused by improper or nonexistent pacing.


Home Previous Next