Remote Control - RF Measurement Commands - Test Configuration

CONFigure:POWer:CONTrol:REPetition <Repetition> ,<StopCondition> ,<Stepmode>

*<Repetition>*	Parameter description	Def. value	Def. unit
CONTinuous \| SINGleshot \| 1 to 10000	Continuous measurement (until `STOP` or `ABORT)` Single shot measurement (until `Status = RDY`) Multiple measurement (counting, until `Status = STEP \| RDY)`	SING	-
*<StopCondition>*	Parameter description	Def. value	Def. unit
NONE	Continue measurement even in case of error	NONE	-
*<Stepmode>*	Description of parameters	Def. value	Def. unit
STEP \| NONE	Interrupt measurement after each statistics cycle Continue measurement according to its rep. mode	NONE	-

Description of command	FW vers.
This command defines the repetition mode and the stepping mode for the measurement. A stop condition is not available.	³V 1.15

Note:
In the case of READ commands (READ: to ) the <Repetition> parameter has no effect; the measurement is always stopped after a single shot.