CONFigure:MULTitone:AF1Channel:TDEFinition
CONFigure:MULTitone:AF2Channel:TDEFinition
<Freq_1>, <Lev_1>, <Enable_1>, ... <Freq_20>, <Lev_20>, <Enable_20>
|
<Freq_nr> |
Description of parameters |
Def. value |
Def. unit |
|
10 Hz to 15999 Hz, |
Frequency of test tone <nr> |
See below |
Hz |
|
<Lev_nr> |
Description of parameters |
Def. value |
Def. unit |
|
1.0 mV to 5.0 V, |
Level at test tone <nr> |
See below |
V |
|
<Enable_nr> |
Description of parameters |
Def. value |
Def. unit |
|
ON | OFF |
Switch on / off test tone <nr> |
See below |
- |
|
Description of command |
FW vers. |
|
This command enables and configures up to 20 test tones. The minimum frequency spacing between two tones is 1 Hz. The sum of all test tones must not exceed the maximum AF generator level quoted in the data sheet. |
V 3.0 |
| The following default test tones are provided: | |||||||
| Tone <nr> | Frequency/[Hz] | Level/[V] | Enable | Tone <nr> | Frequency/[Hz] | Level/[V] | Enable |
| 1 | 300 | 0.01 | ON | 11 | 1700 | 0.01 | ON |
| 2 | 440 | 0.01 | ON | 12 | 1840 | 0.01 | ON |
| 3 | 580 | 0.01 | ON | 13 | 1980 | 0.01 | ON |
| 4 | 720 | 0.01 | ON | 14 | 2120 | 0.01 | ON |
| 5 | 860 | 0.01 | ON | 15 | 2260 | 0.01 | ON |
| 6 | 1004 | 0.01 | ON | 16 | 2400 | 0.01 | ON |
| 7 | 1140 | 0.01 | ON | 17 | 2540 | 0.01 | ON |
| 8 | 1280 | 0.01 | ON | 18 | 2680 | 0.01 | ON |
| 9 | 1420 | 0.01 | ON | 19 | 2820 | 0.01 | ON |
| 10 | 1560 | 0.01 | ON | 20 | 3000 | 0.01 | ON |
Note:
If the level of all test tones is derived from a total level (TLEVel setting in the CONFigure:MULTitone:AF1Channel:TDEFinition:MODE command), the individual level settings are ignored. The <Frequency> and <Enable> parameter settings are still effective.